LR3 Cat Sensor Troubleshooting
If your Litter-Robot is not detecting your cat, watch this Cat Sensor Troubleshooting video:
The globe must be at cat-ready Home position with a solid blue light. With the unit powered ON, unplug the power supply from the base and wait 10 seconds. Plug the unit back in, allow it to complete the start-up cycle, and follow the steps below.
- Hold the Cycle button for 5 seconds. Both blue AND yellow lights are now on.
- Hold the Cycle button for 5 seconds. Yellow light turns off, blue light remains lit.
- Activate the cat sensor by pressing on the globe just above the entrance in a forward and downward motion. The red light should engage. (NOTE: To activate CATS, press on the top of the globe entrance in a downward motion that pushes away from your body.
- Press the Reset button to clear this status and proceed to troubleshoot.
- Press the Cycle button. The unit should cycle and return to Home with a solid blue light.
- Adjust your cat sensor by pressing the Reset button.
- Test CATS by pressing on the globe just above the entrance in a forward and downward motion. The red light should engage.
- If the red light does not turn on after applying pressure, check your unit placement (below).
Unit Placement Tips (Common issues):
- Avoid pushing the unit into a corner or against a wall. Ensure nothing is resting against the unit.
- Remove any mats from under the unit. Place it on a solid, firm surface for best results.
- Always press Reset when adding litter, removing waste, or moving the unit. Press Reset with the unit showing a blue solid light.
- Do not rest on the unit when pressing Reset.
- Use 8-10 pounds of clay clumping litter (standard weight). Alternative/lightweight litter can cause issues with the unit weight system.
- For safety, cats under 5 pounds may not trigger the unit. Manually cycle the unit until your cat reaches a safe weight of 5+ pounds.
- Make sure the unit is in a cool, dry location. If you wouldn't put your computer there, don't put your Litter-Robot there!